How we calculate
The page describes how formulas, waste factors and yield figures are chosen, which sources they come from and when they were last checked. It also says that every worked example comes from the same code as the calculator.
How we calculate
Every calculator follows a written method: a geometry formula, a published manufacturer or trade association table, or a standard unit definition. The method is shown on each page in plain words, next to a worked example made by the same code as the calculator.
How a figure gets onto the site
- We read the figure in its source and record it with the date it applies from and the date we checked it.
- Each calculator is tested against a set of known answers before it ships, including worked examples we can check by hand.
- Each set of figures has a next review date. Waste figures, product yields and electricity prices are reviewed more often than unit definitions.
- When a figure changes we add the new version from its date and keep the old one, and note the change on Rule updates.
Waste and coverage
Waste is the extra you buy for cuts, breakage and mistakes. Some waste figures come from a manufacturer or trade association guide. Others, such as the usual extra for tile, roofing or studs, are common trade practice that no standard states; those pages carry a visible provisional label, show the percentage used and let you change it. Your supplier knows your product best.
How we round
Counts of things you buy are always rounded up: you cannot buy half a box. We clear tiny calculation noise first, so an exact answer of 13 is not turned into 14. Areas and volumes are shown to two decimals, and every page says what it rounded.
What we do not cover
- Structural design. The rafter and truss pages give lengths and counts, not loads, spans allowed by code or a statement that a design is safe.
- Local building code. Spacing, plate rules and permit rules differ by place.
- Prices we cannot source. Where a page shows a cost, it uses a price you enter or a published average with its month.
Every source is on Official sources and every change on Rule updates. To report an error, use Contact and report an error.
Last checked on Oct 10, 2026.
The government and standards pages each rule on this site comes from, grouped by topic, with the tools that use each one and the date we checked it.
Rule updatesChanges to the rates, limits and tables behind our tools, with the date each one applies from and the tools it affects, newest first.